• Solids Content: 76% (SiO2) at 99.9% Purity
• Hardness: >9H (Who Cares)
• Chemical Resistance: Extreme, 0-13ph
• Durability: 15,000+ miles or 1+ years real world tested (lab tested for over double, our competitors would claim this)
• Film Thickness: ~3-4 micron
• Flash Time: 1-5 minutes (2-3 on average)
• Coverage: 10-15ml per wheel set
• Water Contact Angle: 110°
• Working Temperatures: 40F to 100F.
• Applicable Surfaces: Wheels
• Shelf Life: 12 months, use within 7 days of opening for best application experience

How to use:

Prep:

The Prep is the most important step of the process, our coating is great but it can not do the prep work for you!

1. Decontaminate the wheel surface using Armour Detail Supply Wheel Cleaner followed by removing further embedded contamination with a clay bar or clay mitt.

2. If swirl marks, or scratches are present, polish the paint to reduce any surface defects and create maximum gloss.

3. Use Armour Detail Supply Panel Prep to remove any oils/residue left from your polishing step. If you did not polish the surface, repeat this step twice to ensure a clean surface.

You are ready to apply Armour Wheel Coating!

Application:

1. After thorough prep prime the applicator with 3 lines start and each subsequent application will only need a small amount, a little goes a long way. 

2. Apply Armour Wheel Coating one wheel at a time. Apply using a methodical back and forth or crosshatch motion making sure to have even coverage. Allow the product to “set up” for 1-3minutes depending on temperature/humidity (generally 1-2 minutes). Look for light hazing to appear before removing.

3. In a small circular motion level coating 95%+ on 1st wipe (short nap, pearl weave), the first wipe will have a slight grab to it, but the product should be picked up easily. If the coating begins to smear, it needs additional time to setup. If the product is very hard to remove, it needs less time before removal. Switch to 2nd towel (plush) for final leveling. Check for any streaks, or high spots which can appear as cloudy or dark spots. Repeat this process per wheel.

4. Use a fresh side of the towel every wheel. 

We highly recommend applying 2 layers for maximum benefits and durability. If you wish to apply multiple layers allow 1-2 hours between layers.

After Care:

Allow product to sit 12 hours at minimum for initial cure. After 4 hours you can apply our Armour Detail Supply AMPLIFY or Ceramic Spray Sealant to protect the coating during its initial cure. After 12 hours the vehicle can be driven and get wet. Do not wash or induce to chemicals for 7 days.