AlumiBond can be painted and bonds well to a wide range of materials. Designed for use on metal buildings, trailer/RV roofs and sides, drain pans, drain pipes, ductwork, boats, canoes, and as a protective coating for surfaces where abrasion and corrosion resistance is required.

AlumiBond bonds to carbon steel, aluminum, galvanized steel, aluminum foil, gypsum board, wood, rubber, tar, polyethylene, polypropylene, polystyrene, fiberglass, brick, concrete, masonry, rubber, thermoplastics, single-ply roofing, etc.

Dimensions

• Roll: W50mm x L15,2 mtrs

Features

• Duct sealing tape - 2 mil high grade aluminum foil with a hybrid EternaBond Sealant. Fuses to rigid ductwork. Will never harden, crack or peel and fall off like other duct sealing products. Lasts as long as the ductwork.
• Composition: EternaBond’s advanced MicroSealant™ Technology - a 100% solids formulation of synthetic resins, thermoplastics and non-curing rubber (non butyl) with a built-in primer. It is bonded to a 4-mil aluminum metal backing. The adhesive coating is protected by a silicone release liner, to be removed prior to application.
• Remains flexible to temperatures as low as -70° F making it virtually impossible to thermally shock the roof causing a leak
• Seals to itself so it can be cut and folded around an object

Specifications

• Adhesion 7.71 kg / in width
• Application temperature 150° F to -20° F ambient
• Flexibility 127mm radius @ -20° F
• Flexibility temperature range -70° F - >200° F
• Insulation resistance 10 to the 6th power megohms
• Low temperature flexibility 12.7mm radius at -34.4°C
• Shelf life up to 5 years
• Tensile strength >1000 psi
• Total thickness 20 mil
• Weathering excellent resistance to wind, rain erosion, and UV

Surface Preparation Surface must be clean and dry. Moisture, dust, dirt, or other foreign matter should be removed. Remove oil and grease, etc. with EternaClean or a non residue cleaner such as acetone or lacquer thinner. Remove salt and other contaminants.

Application Install RoofSeal/OneStep over the repair area, removing the release liner gradually to prevent contamination of the adhesive prior to application. Rub or roll with pressure using your hand or a steel roller to activate bonding process. This material may be applied to clean dry surfaces from 66°C to -29°C ambient. Treat surface with EternaPrime for installations from 5°C to -29°C ambient.