Installation:

• 1. Fold 3/4” at the edge of the exhaust wrap, tuck the 3/4” fold under the exhaust wrap, and place on the pipe. This reduces fraying on the end of the wrap.
• 2. Make one full initial wrap around the pipe, roughly around pipe 3 to 4 more times, secure wrap at flange with locking tie.
• 3. After securing end, continue to wrap around pipe, using 1/4” overlap with each pass, and keeping tension on the exhaust wrap.
• 4. If primary tubes become so close together, wrap multiple pipes as one. If bend less than 90°, add approximately 8” of wrap; if bend greater than 90°, add approximately 14” of wrap. And maintain the same 1/4” overlap.
• 5. On the final pass around the pipe, fold over about 3/4” of the wrap, and tuck it underneath itself. Then secure the last coil of wrap with locking tie.