Part Numbers

This ecu will interchange or replace 2007 Ford Fusion or 2007 Mercury Milan vehicles with a 3.0L engine and one of these part numbers:

6E5A-12A650-ADA

6E5A-12A650-ADB

6E5A-12A650-ADC

6E5A-12A650-ADD

6E5A-12A650-ADE

6E5A-12A650-ADF

6E5A-12A650-AJA

6U7A-12A650-BHA

6U7A-12A650-BHB

6U7A-12A650-BHC

7E5A-12A650-XA

7E5A-12A650-XB

7U7A-12A650-CA

7U7A-12A650-CB

Fitment/Interchange

This ecu will interchange or replace the following vehicles with a 3.0L engine and has one of the part numbers listed above:
• 2006 and 2007 Ford Fusion
• 2006 and 2007 Mercury Milan with a 3.0L engine

Tech Notes

ECU has been tested with our state of the art vehicle simulator which tests over 25 circuits of the ECU! Some of those are listed below:
• Reference Voltage Good!
• ECU powered up and has communication!
• ECU fuel pump/main relay tested good!
• ECU injectors/coils tested good and much more!
• This vehicle has known issues with the coils and spark plugs. When these fail the ECU will be damaged. In order for the warranty to be valid, you need to make sure the vehicle's coils have been replaced with Motorcraft DG514 and the spark plugs have been replaced with Motorcraft SP433 before the ECM is installed. If these units have not been replaced prior to the ECM being installed, we will not be able to warranty this item in the event the injector/coils are damaged in the ECU.   

Install Notes

• Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
• Disconnect and remove the module to be replaced.
• Install and connect the replacement module.
• Connect the negative terminal of the battery.
• See "Programming / PATS Security" below for additional install instructions.

Programming / PATS Security

For Plug and Play you must do the following three steps:

Step 1: Match your part number per above fitment guide

Step 2: Program ecu to your VIN. Along with PATS programming your local locksmith in mosts cases can perform this task for you along with step  3. If not you will need to see your local mechanic. 

Step 3: If your vehicle has PATS security (Most Ford/Lincoln/Mercury's do) you must have your keys programmed. We recommend you have this done by your local locksmith. In most cases they will travel to your location and the process takes less than 30 minutes. No towing necessary and your local locksmith will be cheaper than a dealer.

Item Condition

• Mounting points are all open and intact
• Pins perfect, none are broken or bent
• Lock tabs in place
• Connector plastic may have minor chip but pins, guides and lock tabs are in place.

Warranty

This ECM comes with a 90 day warranty from the date of purchase. Please keep a copy of your purchase record which we will send with your item.

This vehicle has known issues with the coils and spark plugs. When these fail the ECU will be damaged. In order for the warranty to be valid, you need to make sure the vehicle's coils have been replaced with Motorcraft DG514 and the spark plugs have been replaced with Motorcraft SP433 before the ECM is installed. If these units have not been replaced prior to the ECM being installed, we will not be able to warranty this item in the event the injector/coils are damaged in the ECU.