Please note:
Matters needing attention (buyers must see)
The product has just been received, you must first turn on the flashlight to discharge, and then charge the product for more than 4 hours, and then start the car, because the product is empty. This operation can prolong the service life of the product!
1. It is recommended to start the car with three bars or more than 60% of the power supply
2. Check whether the pile head of the battery is clean
3. Start the car with ordinary clip: Check whether the blue port of the clip is inserted to the end, whether the clip touches the positive and negative poles of the battery with the largest area, and whether the clip is stable and does not shake. First, clip the positive and negative poles of the clip to the positive and negative poles of the battery On, wait 2 to 3 minutes before starting the car. This operation can reduce the load on the power supply

Tips before use:
【1】The car cannot be continuously ignited to start the car / or the key is not released, and the next start will be carried out after 30 seconds between each start
【2】The positive and negative poles cannot be reversed. Two clips cannot be connected short-circuited.
【3】Remove the clip within 30 seconds after successfully starting the car.
Violation of the above 3 points may cause the [fuse box] of the clip to burn out, please pay attention to the operation method.

Specifications:
Peak Current :1200A
Starting Current :600A
Car Jump Start Output :12V
USB Output 5V/2A
Gas Engine Rating :Up to 4.0L
Operating Temperature :-40℃-80℃
Diesel and steam double start strong power

Packing List:
1*Battery clip
1*Instruction
1*USB cable
1*carton packin