Module has been tested by our experienced technical staff! Some of those tests are listed below:
• Module powered up as expected and has communication
• Wheel speed sensors circuits good
• Precharge Pump circuit tests good
• Brake Switch input good
• DSC and HBC Switch input good
• Fluid Pressure sensor circuit good

Install Notes

Please follow below for proper installation of module. If you don't follow these steps you can surge the unit and kill the board. If this happens, we cannot take a return as we test, power and communicate with all of these units. 
• Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
• Disconnect and remove module to be replaced. Make sure connector harness is clean and there are no broken wires.
• Install and connect the replacement module.
• Connect the negative terminal of the battery.
• EBCM will require intialization at this point.
• After install clear Diagnostic Trouble Codes and drive vehicle for 1 or 2 days. This will allow the vehicles monitoring system to reset.
• Clear codes again and no codes should reappear.

Warranty

This EBCM carries a 6 Month warranty from the date of purchase. Please keep a copy of your sales record which we will send with your order.