Built for Aussie refrigeration tradies: the Embraco Aspera NEU6214Z is a fully hermetic R134a HBP compressor designed for reach-ins, display fridges and beverage merchandisers where reliable pull-down matters. It’s a tidy 220–240 V, 50 Hz, single-phase unit with CSIR High Start Torque (HST) so it kicks over cleanly on warm heads and busy shop loads — no dramas.

Key Features & Benefits

• R134a HBP duty — suits typical reach-in and merchandiser operating conditions for steadier case temps.
• High Start Torque (CSIR/HST) — helps reduce nuisance trips and “won’t start when it’s hot” call-backs.
• Solid real-world capacity — approx. 1.48 kW at +5 °C evap / +50 °C cond (EN12900 reference) for common cabinet loads.
• UNI base + standard stubs — faster swaps in tight cabinets with 8.1 mm suction and 6.1 mm discharge/process tube stubs.
• Trade-friendly servicing — factory oil charge and standard electrical supply keeps the job straightforward when you follow good install hygiene.

Why This Compressor Matters

When a merchandiser is drifting up in temp every arvo, the fix is rarely “just gas”. A correctly sized HBP compressor that starts reliably under load is what saves stock and stops repeat visits. The NEU6214Z is a dependable choice when you need clean starts, stable performance, and a footprint that doesn’t fight you during the change-out.

How to Install & Use (Tradie-Friendly)

1. Confirm match: verify HBP application, capacity, base footprint (UNI) and tube sizes against the original compressor/plate.
2. Replace the drier: always fit a fresh liquid-line drier on compressor swaps.
3. Nitrogen pressure test + purge while brazing: keeps the system clean and helps avoid oxide scale.
4. Pull a deep vacuum: use a micron gauge, isolate, and run a decay test before charging.
5. Charge by weight: weigh in to spec, then verify operating conditions and airflow.

Tip: If you want a refresher on best-practice evacuation readings and decay testing, use our in-house guide: Perfect Vacuum Measurements with a Micron Gauge.

Compatibility & System Info

• Refrigerant: R134a
• Application: HBP
• Electrical: 220–240 V, 50 Hz, single-phase
• Start type: CSIR (High Start Torque)
• Typical capacitors: Start 88–108 µF / 330 V; Run 15 µF (always verify nameplate/kit)

Limitations & safety: This compressor is specified for R134a HBP applications. Don’t “mix and match” refrigerants. Isolate power before work, pressure-test safely, and keep POE systems clean and dry to prevent moisture-related failures.

What’s Included

• 1 × Embraco Aspera NEU6214Z hermetic compressor (factory oil charge)
• Integrated motor protection/relay (as supplied)
• Installation leaflet (where supplied)
• Note: Start/run capacitors and mounting grommets may be sold separately — check contents on delivery.

Specifications

Shipping & Returns

Covered by manufacturer warranty and supported by our Shipping & Returns process. Keep packaging until commissioning is complete.

FAQs

Why Buy From HVAC Shop

• Australian-owned store with local support
• Fast shipping on trade gear (see Shipping & Returns for details)
• Secure checkout and straightforward warranty process
• One place for compressors, vacuum gear, gauges and start components

Related Products

• Relay & Overload Combo — a smart swap during compressor change-outs.
• Start Capacitors — pick the correct µF/voltage for CSIR starts.
• Run Capacitors — match the run cap spec to keep amps stable.
• Bradley NR1000 Nitrogen Regulator — pressure test and purge before evacuation.